Royal Army Pay Corps ( RAPC ) Matched Facing Pair of Silver Plate and Gilt Collar Badges, post 1952
Die cast, two part construction, with two silver plated lugs to the reverse of each. Matched facing pair. Lovely condition.
A181.2 read more
Royal Electrical Mechanical Engineers ( REME ) Bi Metal Badge, 1947 - 1952, Gladman & Norman
A scarce post WW2 issue cap badge with original slider and correctly marked with a genuine maker's mark in three lines, Gladman & Norman, Spencer Street, Birmingham 18. Has seen a lot of wear worn and has polishing to the detail, orb of crown bent over, but a good honest badge with a scarce maker details.
A149.2 read more
WW2 Vintage Royal Artillery ( RA ) Brass Beret Badge - Dowler
A small pattern die struck cap badge with two original lugs and a slider. Not sure why all the extra fittings were needed, but have seen this before on other versions of this cap badge. Slider stamped Dowler, Birmingham. Circa 3.7cm tall. Some service wear, scroll letters have some flattening, otherwise in good condition.
A61.2 read more
Matched Pair of Royal Engineers ( RE ) Officer's OSD Collar Badges - 10 flames!
Royal Engineer ( RE ) bronze grenades (unusally with ten flames!), with two original lugs to each. Circa 4.7cm tall. Very good condition with sharp detail, note some bending / service wear to lugs). read more
Royal Engineer Services Gilt Cap Badge - Worn by Officers only
Two original lugs to the reverse. Circa 3cm in diameter. In good condition. Scarce.
K&K Vol 2, No 1943 refers. read more
Unique 268 ( Warwickshire ) Royal Artillery ( TA ) Gilt and Silver plate Collar Badge
Unique collar badge to the 268 ( Warwickshire ) Field Regiment, Royal Artillery, circa 1950s. All ranks wore small gilt grenades with silver Ubique scrolls below as collar badges on their battledress blouses. (See Plate 59 and Fig. 314 in Norman Litchfield's book)
.
A high gilt and silver plated two part construction metal collar badge with two original lugs. Embo... read more
Military Provost Staff Corps OSD Officer's Bronze Cap ( GV ) badge - Gaunt
A scarce WW1 vintage OSD die cast bronze cap badge with two original blades and back stamped JR Gaunt London. In excellent condition. Cannot have been many of these made.
K&K Vol 1 no 1054 refers. read more
Scarce Tyne Electrical Engineers Chrome Pipers Badge
A good post war chrome example of this scarce badge with two original lugs to the reverse. Circa 7.1cm tall and 6cm wide. In very good condition. read more
WW1 Royal Artillery Economy Pattern Cap Badge ( unvoided wheel)
An unvoided WW1 Economy Issue pattern Cap Badge to the Royal Regiment of Artillery in good but as worn condition, with original slider. read more
Royal Artillery Small pattern Beret Cap Badge - Gaunt
Small pre 1952 beret pattern cap badge - a real belts and braces this one - with slider and two orignial lugs! The slider has JR Gaunt.London on the reverse. Do not be put off by the full stop after Gaunt. This is the correct small pattern name stamping which DID use a full stop. The naming is the 13mm long and about 1mm tall. Badge is circa 4.5cm wide and 3.4cm tall. Good condit... read more