The Quartermaster's Store

QEII Royal Artillery Anodised Small Beret Badge and Collar Set - all JR Gaunt London marked

A small pattern beret badge, circa 3.6cm tall and two matching collar badges with single lug fixing to the reverse of each, all marked JR Gaunt London to reverse. Pre 1970s. In excellent unissued condition. read more

Code: 58394

Royal Engineer ( RE ) Officer 's Gilt and Silver plate Matched Collar Badges

A stunning pair of high gilt and silver plated two part construction metal collar badges with two original lugs to each. Circa 32mm tall. Note nine flames as worn by RE as opposed to seven as worn by RA. Slight verdigris to reverse of one badge.
read more

Code: 58195

Royal Engineer Officer's Matched Pair of Fire Gilt Collar Badges, stunning

A super large pair of matched collar badges in fire gilt and amazing condition. Two original lugs to the reverse. 9 flames to each. Circa 4.7cm tall.

Churchill & Westlake No 351 refers.
read more

Code: 58194

WW2 Royal Electrical & Mechanical Engineers ( REME ) 1st Pattern Brass Cap Badge

A brass cap badge to the Royal Electrical Mechanical Engineers with original slider to the reverse. In good condition. First introduced in 1942, replaced with second pattern in 1947.

Coll.

K&K Vol. 2 No 2127 refers. read more

Code: 58193

Royal Army Medical Corps ( RAMC ) Officers Silver plated and gilt Cap Badge, pre 1953 - Gaunt London

An attractive and well made die cast cap badge with two original silvered long lugs (slight wear) to the reverse and embossed to the rear with the maker's details JR Gaunt London. King's crown, so pre 1953. In good condition with slight tarnishing to plate. Gilt still reasonably bright.
read more

Code: 58192

Royal Army Service Corps ( RASC ) Other Ranks Cap Badge - George V

Scarce cap badge with original slider. Slight touch of verdigris to bottom right of star, otherwise in very good condition. For some reason these were not issued until later during his reign and are surprisingly hard to find.

Coll read more

Code: 58191

Royal Army Pay Corps ( RAPC ) Bi-metal Beret Cap Badge

King's crown smaller pattern bi-metal cap badge as worn in the beret with original slider. Some verdigris to slider but will clean up. Circa 3.4cm tall and 3.6cm wide. I was told by vendor that this particular badge was worn by an officer. It came with the silver and gilt collars listed below, but is not of the same finish or quality.
read more

Code: 58190

Royal Army Pay Corps ( RAPC ) Officer 's Matched Facing Pair of Gilt and Silver Plated Collar Badges

16.00 GBP